SICO | ProLuxe Cetol 1

This premium translucent exterior wood stain delivers a natural, grain-enhancing look with a durable satin finish. Built on alkyd oil technology, it penetrates and protects wood with UV resistance, water repellency, and weather protection. Use it alone or as a basecoat to be used with Cetol 23 Plus.

• Translucent finish highlights natural grain while adding protective color.
• Superior UV protection helps reduce fading and sun damage.
• Water repellent performance helps resist moisture intrusion.
• Weather resistant for demanding outdoor exposure.
• Flexible & breathable to help reduce cracking and peeling from movement.
• Highly transparent for a clean, premium look.

Note: Label may appear different upon pickup.

Colours shown are approximate and may vary by wood species, porosity, and prep. Always test a sample on your surface before full application.

• Wood must be clean, dry, and free of dirt, grease, grime, mildew, mill glaze, and old coatings.
• Wet the surface with clean water before cleaning.
• Clean with: 4 oz powdered TSP (or substitute) + 1 qt bleach + 3 qt water.
• Scrub 15–20 minutes. Do not let solution dry on the surface.
• Rinse thoroughly using 500–800 psi, nozzle 8–12 in away.
• Let dry 48 hours or until moisture content is 18% or less.
• Sand: 80–120 grit (vertical) | 60–80 grit (horizontal). Sand with the grain and remove dust.
• Apply finish within 1 week (horizontal) or 4 weeks (vertical) if the surface stays clean.

Lead Warning: Scraping or sanding old paint may release lead dust. Use a NIOSH-approved respirator and follow EPA lead-safe practices.

• CAUTION: Surfaces are slippery when wet.
• Test absorbency: if water absorbs within 30 sec–2 min, wood is ready. If not, wait 30 days and re-test.
• Test your color on a small area first. Intermix containers to reduce color variance.
• Stir thoroughly before and during use. Do not thin.
• Do not apply in direct sun or if rain/snow/heavy dew or temps below 40 °F (4 °C) are expected within 48 hours.
• Preferred: natural bristle brush. If rolling or spraying, back-brush immediately.
• Apply one even coat with the grain. Maintain a wet edge and avoid heavy application to reduce lap marks.
• Coat end grains and board backs (when possible) for best protection.

To maintain protective performance, apply a maintenance coat when wear becomes visible. Clean and prep the surface as described above. Areas with minimal wear may only need a light coat. Hardwoods and lighter colors may require more frequent maintenance.

• DANGER: Combustible liquid and vapor. Harmful or fatal if swallowed.
• Use adequate ventilation during and after application and drying.
• Avoid breathing vapors, mist, or sanding dust. Avoid eye/skin contact.
• Spontaneous combustion risk: Oil-soaked rags/steel wool/waste can ignite. Store immediately in a sealed, water-filled metal container.
• Keep out of reach of children. Read label/MSDS before use.

• Is this a wood stain or a paint?
  • It’s a translucent exterior wood stain designed to enhance grain while protecting against sun and weather.
• How many coats should I apply?
  • Apply one even coat following the grain.
• Can I spray it?
  • Yes. Use an airless sprayer with a .011″–.015″ tip at 700–800 psi and back-brush immediately.
• How long until it dries?
  • Touch dry in ~12 hours, light foot traffic in 24–48 hours, furniture after 72 hours.
• What’s the coverage per gallon? Rough wood: 150–200 sq ft/gal. Smooth/hardwoods: 250–400 sq ft/gal.